ESU LokPilot Micro V4.0, DCC, 6-pin NEM651 direct connection

  • 0 Units in Stock
  • Model: ESU54685
  • Shipping Weight: 0.5lbs
  • Manufactured by: ESU(LokSound)
$32.59

LokPilot Micro DCC with direct-connect 6-pin (NEM651) plug.

NOTE: The picture does not show this decoder. It has a 6-pin plug connected directly to the decoder -- no wire harness.

The LokPilot micro V4.0 DCC is a genuine power house. It drives the loco motor with a continuous load capability of 0.75A and has significantly shrunk compared to its forerunner: the smallest member of the LokPilot V4.0 family has now a size of only 10.5mm x 8.1mm x 2.8mm and should thus fit in the smallest N-/TT-gauge locos.

Operational modes

The LokPilot micro V4.0 DCC commands DCC through 14, 28 and 128 speed steps or can be used on analogue DC layouts. You can either use 2- or 3-digit (1 – 127) as well as 4-digit (1–9999) addresses or assign a consist address.

It supports all common DCC brake systems such as Lenz® LG 100 as well as the new Lenz® ABC brake modules with asymmetrical DCC signals, or the braking in DC braking sections with reversed polarity.

MSRP is $41.90.