DCC Specialties Jack Wabbit Quad™ for all Turnout Motors

DCC Specialties Jack Wabbit Quad:
The Jack Wabbit™ is a Quad version of the popular DCC Specialties Hare and Wabbit Intelligent Accessory Decoders. This decoder has four fully functional intelligent decoders on one printed circuit board. The four decoders operate independently and each one has all of the advanced features and much more, compared to the popular Hare and Wabbits. The Jack Wabbit is compatible with all types of turn-out motors, including stall motors, snap coils, servos and all others! 

• Auto Throw™
  Automatically throws points when a train is approaching against the points!
• Auto Throw™ Timer
  Provides for timing the auto throw function to prevent two trains from colliding.
• Auto Return™
  Automatically returns the points after a preset interval for any/all operational events.
• Smart Route™ 
  Sets up to 13 routes by simple address programming in addition to the primary address.
• Dispatcher Over-Ride™
  Allows the Dispatcher to lock out any or all other switch commands.
• Lock Block Protection™
  Overrides the Jack WABBITS operation if a designated block is occupied.
• Locked Route Control™
  Provides for only one route direction response for a Throw or Clear command.
• Smart Default Ops™
  Programmed power up response to either power off position, throw, or clear.
• Operate Switch Signals or Panel LED Indicators by direct LED connections.
• Manual Pushbutton or Toggle Switch
  Allows button or toggle switch manual control of the points.
• DCC Reset
  CV 63=42, Sets Any or All Addresses and CVs to original factory default values.
• Decoder Reset By Jumper
  Jumper selection resets entire Jack Wabbit to factory default Address and CVÂ’s.
• Direct Current Ops
  The JACK WABBIT will operate on DC using the Manual Push Button Control Option.
• Semaphore/Gate Ops
  Uses a stall motor and Auto Throw for triggered control of a semaphore or crossing.
• Automates Reverse Loop Turnouts 
  Using Auto Throw feature.
• Feed Back, Turnout Position Reporting to
  Digitrax (LocoNet), Lenz (ExpressNet) and NCE (Cab Bus)

For more information, please visit this product's webpage.