HARNESSES/CONNECTORS

DCC Harnesses are used to make it easier to connect  (or disconnect) a decoder to a locomotive. The connector at the decoder end is usually the 9-pin "JST" connector, while the locomotive end can be anything from bare wires to solder, to an NMRA 8-pin plug.

View As :
     

Harness Set, 3-Pin Connector, 4" Wires (Red/Black/Yellow)

Harness Set, 3-Pin Connector, 4" Wires (Red/Black/Yellow)

$1.12
$1.12

HARNESS SET; 3-PIN CONNECTORS, 4" LONG WIRES (Red/Black/Yellow) Single Pack

Add:
+ Add to Wishlist+ Add to Compare
Harness Set, 2-Pin Connector, 4" Wires (Red/Black)

Harness Set, 2-Pin Connector, 4" Wires (Red/Black)

$0.79
$0.79

HARNESS SET; 2-PIN CONNECTORS, 4" LONG WIRES (Red/Black) Single Pack

Add:
+ Add to Wishlist+ Add to Compare
TCS Connector, 6-Pin JST

TCS Connector, 6-Pin JST

$0.75
$0.75

6-pin micro-JST surface mount female connecter - used on the backside of the T4X-T6X for the VO-1.5 MSRP $0.95   

 Call to Order + Add to Wishlist+ Add to Compare
TCS Connector, 7-Pin JST

TCS Connector, 7-Pin JST

$0.75
$0.75

7-pin micro-JST surface mount female connector - used on the MC series of decoders. MSRP $0.95   

 Call to Order + Add to Wishlist+ Add to Compare